![]() ![]() ![]() One of the first things I did was take a look at the safety and security of the establishment. The couple that lived there hadn't renovated since it was constructed nearly three decades ago. I recently purchased a house that needed a lot of work. Click here for more information on Electronic Recycling Programs.*Check with your state and local fire and Building/Safety codes for specific information regarding smoke & Carbon Monoxide Alarms.When any one interconnected alarm is triggered, all interconnected alarms within the home sound an immediate warning.Kidde offers a full range of 120V AC wire-in life safety products with interconnect capability to provide the most immediate and complete system available.Add a Kidde Fire Extinguisher to complete your Fire Safe Home.Smoke and carbon monoxide detectors utilize a photoelectric sensor to detect fire hazards and sound an 85 db alarm when a hazard is detected.Alarm uses electrochemical sensor to detect carbon monoxide.Photoelectric smoke sensor-may detect visible fire particles associated with slow smoldering fires sooner than an ionization sensor.Green LED light indicates that the alarm is working properly.Alarms are equipped with test/reset button which tests the alarms circuitry and horn and resets memory after an alarm has sounded.Seven years after initial power, the unit will chirp to indicate that it's time to replace the entire unit.Front-load battery compartment makes it easy to replace the alarm's 9V backup battery.Smart hush feature temporarily silences nuisance alarms and low battery chirps.Voice alarm announces "Fire! Fire!" when a smoke or fire hazard is detected and "Warning! Carbon Monoxide" when CO is detected.9-Volt battery backup provides protection during power outages.Smoke and carbon monoxide detectors should be installed in a central location outside each sleeping area, on every level of the home, and in other locations where required by law.Existing buildings are allowed to use battery powered smoke alarms without physical interconnection, but are required to provide hardwired interconnected smoke alarms in compliance with the requirements applicable to new buildings where work is being done that results in the removal of interior walls or ceiling finishes exposing the structure, or where there is an attic, crawl space or basement available that could provide access for hardwiring without removal of interior finishes. In new buildings, all the alarms have to be hardwired with battery backup (subject to certain exceptions), and if more than one smoke alarm is required to be installed within a dwelling unit, they have to be interconnected so that if one goes off they all go off. In split levels, not divided by a door, the upper level alarm serves as the lower level alarm. Smoke Alarms:Īll existing residential buildings that contain sleeping units or dwelling units must have a smoke alarm installed in every room used for sleeping purposes, on the wall or ceiling of each separate sleeping area in the immediate vicinity of bedrooms, and one on each story within a dwelling unit including basements and habitable attics. In any existing building with dwelling units, that has either fossil fuel, burning equipment or an attached enclosed garage, a carbon monoxide detector must be installed in the immediate vicinity outside of each sleeping area or grouping of bedrooms in the dwelling unit with very limited exceptions. ![]() DOB Enforcement:ĭOB enforces the requirements pertaining to the installation and maintenance of smoke detectors and carbon monoxide detectors through the issuance of a “Notice of Infraction” to property owners who fail to comply with the code. To view the Updated Property Maintenance Code, click here. The District of Columbia Property Maintenance Code (2017), referred to as the “Property Maintenance Code,” requires the installation of carbon monoxide alarms in all new and existing residential and institutional dwelling units with a carbon monoxide source, including but not limited to apartments, condos, one and two-family houses and townhouses, dormitories and residential institutions. Both property owners and tenants have responsibilities to ensure that all District residents remain safe in their homes from the dangers of fire and carbon monoxide poisoning. The District of Columbia law/code requires the installation and maintenance of smoke alarms and carbon monoxide alarms in buildings with residential occupancies in the District of Columbia. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |